Specification
Description
The PRP Aluminum Sure Seal Base, 1/2" Tall (Part #CM124) mounts between the carburetor and an air cleaner housing to seal the base of the air filter assembly. Machined from extruded aluminum, it uses an O-ring at the carburetor neck to keep unfiltered air and dirt out of the intake.
This 1/2" tall, low-profile base is intended for setups where hood or linkage clearance is tight, while still providing the secure, sealed connection of the PRP Sure Seal system. It pairs with standard Sure Seal air cleaner housings and replacement O-rings.
Disclaimer
This product must be correctly matched to your application's requirements (fluid type, pressure, and fitment) before use. Improper selection, installation, or use may result in product failure, leakage, or damage, and could cause serious injury. Installation by a qualified professional is recommended. This product may contain chemicals known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.